Search found 6 matches
- Tue Feb 16, 2021 6:44 pm
- Forum: Antique Stationary Engines
- Topic: Sorg reciprocating cylinder engine on auction
- Replies: 4
- Views: 10440
Sorg reciprocating cylinder engine on auction
I just discovered what is supposedly a Sorg reciprocating cylinder engine at a local on-line auction. The auction is over in a day, Feb 17th, so not likely for anyone to get there to take a look at it. These are a pretty uncommon engine and it will be interesting to see what it sells for and if it s...
- Fri Oct 25, 2019 6:48 pm
- Forum: The Junk Drawer
- Topic: Rodents like wiring.
- Replies: 44
- Views: 40104
Re: Rodents like wiring.
I have a light switch in our house that for some reason attracts mice. They manage to get into the electrical box and then touch two terminals and electrocute themselves, and in a couple of days they start to stink. Once it was two mice at the same time, and another time the light controlled by the ...
- Thu Dec 23, 2010 3:07 pm
- Forum: General Discussion
- Topic: Shop layout ideas?
- Replies: 15
- Views: 15435
Re: Shop layout ideas?
Thanks for the suggestions and tips. I'll keep your ideas in mind as I plan the layout and get working on the shop. I primarily want to avoid anything that will be hard to change later.
Jim
Jim
- Mon Dec 20, 2010 12:15 pm
- Forum: General Discussion
- Topic: Shop layout ideas?
- Replies: 15
- Views: 15435
Shop layout ideas?
Hello all I am new to this forum, and have been reading a lot, and looking through older posts, but haven't found what I am looking for now. I am rearranging my shop area, which is in our barn, and am expanding the area that I will be using to about 20'x30'. At present I have a Grizzly G1126 mill-dr...
- Fri Nov 26, 2010 2:20 pm
- Forum: General Discussion
- Topic: Making and/or iinstalling a bushing?
- Replies: 7
- Views: 3358
Re: Making and/or iinstalling a bushing?
Thanks for the help. I had noticed the cored material on some websites, but wasn't sure if this was what I should get. I will also give a bearing supply a call--don't know why that hadn't occurred to, but thanks for that suggestion, too. The bushing is for the lower support of the mounting tube of o...
- Wed Nov 24, 2010 9:44 am
- Forum: General Discussion
- Topic: Making and/or iinstalling a bushing?
- Replies: 7
- Views: 3358
Making and/or iinstalling a bushing?
Hello all, I am new to the forum, although I have been reading it for a long time. I am now finding time to use my shop more, and although I took an evening adult metal shop class through our local university for a few semesters a a couple of years ago, I have lots of questions. The class was great,...