George Gaskill
-
- Posts: 62
- Joined: Wed Jan 08, 2003 7:36 pm
- Location: Poetry, Texas
- Contact:
George Gaskill
George, I am slow, but am taking material to a friends EDM shop and they are going to make my L46 Sako sear bar. I have a dxf file and will drill and ream the one hole in the part and drill a starter hole for them. If it had cost me money, I would have made it myself. I am waiting on a #2 Shilen .224X14 chromoly blank. It will be a 22" .222. Thanks for all your help. Butch
Re: George Gaskill
Pardon me for butting in, but has Brownells quit selling Sako parts?
Al Messer
"One nation, under God"
"One nation, under God"
This was for a '60's Sako 469 action.
I didn't check Brownell's; don't know if Butch did. Would be surprised if they had this particular part.
Re: George Gaskill
Dear Sir
Do you have a drawing of the sear to a Sako L46? I have one of these fine rifles but withouot its sear. It is of the type like the old Winchester 70 trigger mechanism. Please reply to my email hkn@connectia.dk
Best regards
Henrik Knudsen
Denmark
Do you have a drawing of the sear to a Sako L46? I have one of these fine rifles but withouot its sear. It is of the type like the old Winchester 70 trigger mechanism. Please reply to my email hkn@connectia.dk
Best regards
Henrik Knudsen
Denmark
-
- Posts: 62
- Joined: Wed Jan 08, 2003 7:36 pm
- Location: Poetry, Texas
- Contact:
Re: George Gaskill
I have a print for the bolt release and sear bar. I believe that I also have a dxf file for both. E-mail at papawlambert@starband.net