 |
The Home Machinist!A site dedicated to enthusiasts of all skill levels and disciplines of the metalworking hobby. |
Login
Register
FAQ
Search| It is currently Thu May 23, 2013 7:22 am |
|
The Home Machinist!A site dedicated to enthusiasts of all skill levels and disciplines of the metalworking hobby. |
| It is currently Thu May 23, 2013 7:22 am |
|
All times are UTC - 5 hours |
 
|
Page 1 of 1 |
[ 2 posts ] |
|
| Author | Message | |||
|---|---|---|---|---|
| farrviewsouth |
|
|||
Joined: Fri Jun 12, 2009 11:43 am Posts: 11 Location: Northwood,NH |
|
|||
| Top |  |
|||
 |
||||
| hammermill |
|
|||
Joined: Sun Jun 27, 2010 10:43 pm Posts: 1539 Location: pendleton or |
|
|||
| Top | |
|||
|
||||
|
|
Page 1 of 1 |
[ 2 posts ] |
|
All times are UTC - 5 hours |
Who is online |
Users browsing this forum: No registered users and 4 guests |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |
..I picked up a DiarlArc 250 and the flat piece that goes from the Amp adjustment shaft to the plastic indicator was bent and twisted out of place. I have just spent two hours, after straightening it so that it has two @ 45 degree bends, trying to reinstall it so that it does not bind or fall off. Anyone familiar with this piece? Does the piece have a more complex bend or is there a particular order to install so that it goes in without binding?