Need Info on Di-acro brake
Need Info on Di-acro brake
Have a Di-acro brake # 1 Model 1873 made by o neil irwin mfg co, Lake City Minn. Know nothing about it, any info or where I could by a manual would be appriciated. Will try to add pictures with questions to this post. Elmer Aydelotte Sebring, Fl
Re: Need Info on Di-acro brake
Gasman, while I'm not very familar with this model brake, I think in your 4th (last)picture, those holes at the handle end are for pre-set bend angles (30, 60, 90, 120). Put a good fitting pin in one of the holes and the handle willl always stop at the same bend angle everytime.
Re: Need Info on Di-acro brake
Gasman -
Here is a link with manuals for various Di-Acro machines.
http://www.neme-s.org/Shaper%20Books/DiAcro/
Your particular size machine is no longer made, but the most similar is the 24" and 36" finger brake.
A.T.
Here is a link with manuals for various Di-Acro machines.
http://www.neme-s.org/Shaper%20Books/DiAcro/
Your particular size machine is no longer made, but the most similar is the 24" and 36" finger brake.
A.T.