Just messing around today, I made this versitile wrench/hammer for my rong-fu mill/drill. It turned out great, and works very well. I took the wrench and milled the end off. Then turned a piece of cold rolled down, machined the slot, and pinned it to the wrench. Finally I made the oversized UHMW "hockey puck", and pressed it on the hammer end with my vise. This is amature to most of you, but I had fun doing it. It was a good day.
The pin I knurled
finished product
I love how oversized the plastic hockey puck end is.
Small project.... Drawbar wrench.hammer
Moderator: Harold_V