Things to make it better!
Moderator: Harold_V
-
- Posts: 1274
- Joined: Thu Nov 01, 2012 10:39 am
- Location: South Central Alberta
Re: Things to make it better!
I had not meant a groove on the shaft; but if that will work, I'd gladly take the credit for the idea!
Re: Things to make it better!
After giving the looseness of the gib lock a little more thought, I think it's better to just leave it alone. By locking it down and putting the lead screw on I ruined my half nut a couple of weeks ago. That was an $80 lesson learned. I'll just retighten it if it flops down again.redneckalbertan wrote:I had not meant a groove on the shaft; but if that will work, I'd gladly take the credit for the idea!
Re: Things to make it better!
I installed my exhaust fan and don't think it's working too well. It's cooler, meaning less hot, at the top but not much difference in the overall heat in the shop. Next step will be to install some insulation on the top and West exposure wall. I really hate thinking about the work involved with moving all the just to get access to the walls. Then there will be installing the air-con after insulating.
The big "shade" tree is no longer there. Lightning hit it and had to have it removed. That's when all my heat problems began in my shop.
Re: Things to make it better!
Ron,
This might make some things better..
- - -
Lathe Modifications Catalog
http://www.cnccookbook.com/MTLatheMods.htm
- - -
Ken.
This might make some things better..
- - -
Lathe Modifications Catalog
http://www.cnccookbook.com/MTLatheMods.htm
- - -
Ken.
One must remember.
The best learning experiences come
from working with the older Masters.
Ken.
The best learning experiences come
from working with the older Masters.
Ken.
Re: Things to make it better!
Thanks Ken! That is really a cool site. Some of them are no longer there though. But the ones that are there are really informative.ken572 wrote:Ron,
This might make some things better..
Lathe Modifications Catalog
http://www.cnccookbook.com/MTLatheMods.htm
Ken.
Re: Things to make it better!
Sorting out that carriage lock is probably a pretty simple fix. Figure out exactly what your thread pitch is, then go onto the MSC Industrial website. Do a search for ratcheting, or adjustable handles. You can get them in plastic or steel. J.W. Winco would be just one good manufacturer. They work just like yours does now, but you pull the handle out towards you and twist, you can then set the handle to whatever position you want. If the threads are sloppy and allow the handle to swing down anyway's? Just wrap some of the threads with a bit fairly thin fishing line. Or, you could just drill the end of the screw, then shove a small spring in that tightly fit's the hole,yet extends out past the end of the screw. That should apply a bit of friction or tension on the threads and keep the handle from dropping. Due to the crappy threads on some of this equipment you might end up redrilling and then retapping to the next larger thread size, use a tap drill that gives you about a 80% thread form. Then install one of those ratcheting handles. Keep the threads oiled to reduce the wear.
Pete
Pete
-
- Posts: 56
- Joined: Thu Jun 04, 2020 2:59 pm
Re: Things to make it better!
An independent 4 jaw chuck. I removed the 5” 3 jaw and replaced it with a 6” 4 jaw. I had bought an 8” 4 jaw but it felt like a little too much weight for the spindle bearings. Never mounted it. Use it for a mill chuck.
40 year retired machinist.