Splitting a G0516 into a separate lathe and mill

This forum is dedicated to those hobbyists with the 3-in-1 metalworking machines. Mill-Drill-Lathes. Tips, techniques, modification and use of these machines is topical.

Moderator: Harold_V

Post Reply
bobz3denver
Posts: 19
Joined: Thu Jan 19, 2012 4:28 pm
Location: Denver, CO
Contact:

Splitting a G0516 into a separate lathe and mill

Post by bobz3denver » Wed Feb 22, 2012 9:22 pm

I'm only posting this because I've read other guys talk about replacing the cord end on the mill. DON'T DO IT! A standard PC power supply cord will take the mill cord end and convert it to a standard 3-prong plug. In addition it'll give you another 3' or so of reach. If you ever decide to put the mill back on the lathe (to sell it or to make room for some real equipment), you'll still have the original plug end.
There are no rules here, we're trying to accomplish something!

Post Reply