Page 1 of 1

Splitting a G0516 into a separate lathe and mill

Posted: Wed Feb 22, 2012 9:22 pm
by bobz3denver
I'm only posting this because I've read other guys talk about replacing the cord end on the mill. DON'T DO IT! A standard PC power supply cord will take the mill cord end and convert it to a standard 3-prong plug. In addition it'll give you another 3' or so of reach. If you ever decide to put the mill back on the lathe (to sell it or to make room for some real equipment), you'll still have the original plug end.