Just tryied to secure a new flange/cover for the chuck side of the lathe spindle through Busy Bee..."not in stock, can take up to 3 months if ordering from China".
So, I'm hoping that the equivalent Grizzly part would fit, but before dropping 100 bucks on part/shipping/brokerage, can anyone confirm that these two machines are that similar at the genetic level?
Thx!
Craftex B2229 and Grizzly 9729: Parts interchangeable?
Moderator: Harold_V
Re: Craftex B2229 and Grizzly 9729: Parts interchangeable?
Good Morning shepdogshepdog wrote:Just tryied to secure a new flange/cover for the chuck side of the lathe spindle through Busy Bee..."not in stock, can take up to 3 months if ordering from China".
So, I'm hoping that the equivalent Grizzly part would fit, but before dropping 100 bucks on part/shipping/brokerage, can anyone confirm that these two machines are that similar at the genetic level?
Thx!
I just was looking at past posts and noticed yours, and
was wondering how you made out with your quest for
the flange/cover. What did you finally end up
doing
Ken.
One must remember.
The best learning experiences come
from working with the older Masters.
Ken.
The best learning experiences come
from working with the older Masters.
Ken.