I have a set of cylinder castings, including the saddle, both cylinders, valve chests and one valve (you can easily fabricate the other one).
John K. has told me that he is 99% sure that these are 1" scale Yankee Shop cylinder castings for the Atlantic and Pacific.
(John sent me a note to say that he thinks that these may be 3/4" scale, not 1" - he's going to take a look at what he has in the shop to see what it matches and what they might be for.).
These have dummy piston valve steam chests.
All castings are unmachined.
$200 including shipping anywhere I can send a USPS flat rate box, or pick them up this weekend (probably Saturday only) at PVLS. They will be on the swap table.
I will also have a pile of misc. tooling and books on the swap table too. Many items priced at $1.
Steve
NOS 1" or 3/4" Yankee Shop Atl/Pac? cylinder castings
Moderators: gwrdriver, Harold_V
NOS 1" or 3/4" Yankee Shop Atl/Pac? cylinder castings
Last edited by SteveM on Fri Sep 07, 2012 7:56 pm, edited 2 times in total.
-
- Posts: 2166
- Joined: Thu May 22, 2003 8:17 am
- Location: Bel Air, MD
Re: NOS 1" Yankee Shop Atlantic / Pacific cylinder castings
The saddle is too tall to be a Friends Yankee Shop Atlantic/Pacific part. I have one of their 1" Atlantics and the saddle is much shorter.
The cylinders look right, though.
Andy Pullen
The cylinders look right, though.
Andy Pullen
Clausing 10x24, Sheldon 12" shaper, ProtoTrak AGE-2 control cnc on a BP clone, Reed Prentice 14" x 30", Sanford MG 610 surface grinder, Kalamazoo 610 bandsaw, Hardinge HSL speed lathe, Hardinge HC chucker, Kearney and Trecker #2K plain horizontal mill, Haas TL-1 lathe.