Flywheel Question

This forum is for Internal Combustion Engines such as Hit 'n Miss, Throttle Goverened One Lungers etc. Repair, Machining, Operation, Buy/Sell/Trade of these engines are all topical.

Moderator: Harold_V

Post Reply
User avatar
vascon2196
Posts: 30
Joined: Thu Sep 10, 2009 12:46 pm
Location: Mass

Flywheel Question

Post by vascon2196 » Thu Nov 19, 2009 10:29 am

Anyone know where I can find cast iron flywheels?

14-3/4" O.D. weighing approximately 13 lbs.

Not too concerned with spoke design.

Thanks,

Chris

Russ Hanscom
Posts: 1439
Joined: Wed Mar 15, 2006 11:10 pm
Location: Farmington, NM

Post by Russ Hanscom » Thu Nov 19, 2009 7:14 pm

There is an outfit with quite an assortment, kind of think they are in Oregon. Sometimes there are ads in HSM or live steam.

Try Marin Model and Pattern.

www.martinmodel.com

User avatar
vascon2196
Posts: 30
Joined: Thu Sep 10, 2009 12:46 pm
Location: Mass

Flywheel castings

Post by vascon2196 » Fri Nov 20, 2009 7:28 am

Thank you Russ!

This is exactly what I was looking for.

Chris

Post Reply