fly wheel
Moderator: Harold_V
-
- Posts: 19
- Joined: Thu Jan 13, 2011 5:45 pm
fly wheel
building a hit n miss engine:Hoppy from Rahout germany (believe was made in GB) the parts are nice machined the only design flaw is the aluminium fly wheel which das not have the mass for a smooth run :I need 2 brass rings 140 mm OD 95 mm ID 15 mm wide ( cast iron will do also ) the rings will be loctite to the alu flywheel! Any body can give me a source or quote? Thanks in advance!
Re: fly wheel
You might want to specify your location.
In fact, if you put it in your profile, it will appear under your name in every post.
Steve
In fact, if you put it in your profile, it will appear under your name in every post.
Steve
Re: fly wheel
Sourcing material to make these out of brass is going to be expensive. The best I could find 1" drops of 360 brass was about 75.00 each + shipping. Cast iron would be ok and only about 30.00 and shipping per piece. You might also look at steel as you can get pipe weld flanges with a big hole already in the middle fairly reasonable as well.
Re: fly wheel
Could you cast lead around it?
Standards are so important that everyone must have their own...
To measure is to know - Lord Kelvin
Disclaimer: I'm just a guy with a few machines...
To measure is to know - Lord Kelvin
Disclaimer: I'm just a guy with a few machines...
Re: fly wheel
I have two brass pipe flanges removed from some old 3" copper pipe that might work. The ID is 2.920" the OD would be 5.5" if they were turned down just enough to get rid of the 4 bolt holes and they are about .5" thick but would be more like .460 to .475 thick range after they were faced. In metric the finished part would be 95 mm ID and approximately 139.7 mm OD and 12 mm wide. Let me know if your intersted, i can just sell you the 2 flanges for $40 + shipping or if you want me to turn them down for you, and then they would be $100 + shipping for the pair.
Hears a pic of one of them.
Hears a pic of one of them.
-
- Posts: 19
- Joined: Thu Jan 13, 2011 5:45 pm
Re: fly wheel
Sounds ok to me i 'm away from home so give me a few days so i can x actly measure the id so i only need to ream it out a little to get a god press fit!
Thanks! Manfred
Thanks! Manfred
Re: fly wheel
Sounds good to me, let me know what you want the ID turned to and I will leave as much as I can on the OD and thickness when I clean them up. I am guessing the shipping will be around $10 in the cont. USA.