Suggestions for cutting fluids
Posted: Mon Feb 18, 2019 3:44 pm
I have lately been having really good results on the faux Bridgeport using carbide end mills and CRC TrueTap Aqua in a spray bottle. It's a bit awkward because I'm spraying with one hand and turning the crossfeed with the other. It's time to investigate better options.
1) Is there a better system that doesn't require compressed air or a wider catchpan around the base of the milling machine? I'm not opposed to installing a wider apron around the base but will have to locate a supplier.
2) If I elect to stay with the spray bottle, is there a more economical solution available other than CRC TrueTap Aqua that works just as well?
Thanks again all,
HJ
1) Is there a better system that doesn't require compressed air or a wider catchpan around the base of the milling machine? I'm not opposed to installing a wider apron around the base but will have to locate a supplier.
2) If I elect to stay with the spray bottle, is there a more economical solution available other than CRC TrueTap Aqua that works just as well?
Thanks again all,
HJ