It was in Nov. 2003 I sought information on the micrometer in this tooling set right here on this forum. Some guys were kind and identified it for me. Here is the thread;
http://www.chaski.org/homemachinist/vie ... tormvulcan
Without that information I wouldn't have known what I had. Here are some photos of what I have and if there is any interest in purchase, please send me a private message regarding that. I think the special micrometer range is given in the thread above but if not ask again and any other questions you have, ask away. Keep in mind you know more about this Storm-Vulcan equipment than I do.
Photos removed, tooling has a new owner. Steve
Storm -Vulcan
- Steve_in_Mich
- Posts: 1119
- Joined: Sat Jan 04, 2003 4:14 pm
- Location: Mid Michigan