Longitudinal DRO fitting.

All discussion about lathes including but not limited to: South Bend, Hardinge, Logan, Monarch, Clausing and other HSM lathes, including imports

Moderators: Harold_V, GlennW

Post Reply
toglhot
Posts: 13
Joined: Mon Nov 26, 2012 6:03 pm

Longitudinal DRO fitting.

Post by toglhot » Wed Nov 22, 2017 9:56 pm

Continued from my previous post 'DRO fitting'.
I also fitted a DRO to the bed for longitudial measurement. The only parts I had to manufacture were spacers to fit behind the standard clamps, a coolant splash guard and a reader bracket which is attached to the carriage. This bracket is in two pieces, I opted to run the bracket below the DRO and then up to the reader so as to stop coolant dribbling down the bracket and onto the reader and bar.
Attachments
dro10.jpg
dro11.jpg
dro12.jpg
dro13.jpg

Post Reply