Acme threads

All discussion about lathes including but not limited to: South Bend, Hardinge, Logan, Monarch, Clausing and other HSM lathes, including imports

Moderators: GlennW, Harold_V

SteveM
Posts: 7763
Joined: Mon Jun 27, 2005 6:18 pm
Location: Wisconsin

Re: Acme threads

Post by SteveM »

Harold_V wrote:Keep in mind, when cutting threads, especially coarse pitch threads, the helix angle is a problem, so the leading edge of the tool may require clearance (relief) that looks excessive. That makes sense because you have to overcome the angle of the helix, plus have clearance.
The Aloris threading tool actually has adjustment screws to tilt the tool for helix angle:
Image
GlennW wrote:Also look at the tool bit closely and make sure it isn't rubbing below the cutting edge from not enough relief.
An easy way to check is to color the tool with Sharpie marker. Anywhere the tool is rubbing, it will take off the Sharpie.

Steve
Post Reply