The Home Machinist!

A site dedicated to enthusiasts of all skill levels and disciplines of the metalworking hobby.
It is currently Sat May 18, 2013 11:05 pm

View unanswered posts | View active topics


Board index » The Home Machinist! » Lathes

All times are UTC - 5 hours




Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
RB211
PostPosted: Sat Jan 14, 2012 12:19 am 
Offline

Joined: Sat Jan 16, 2010 9:29 pm
Posts: 786
Location: Spring Hill, Florida
I always liked Taigs 3 jaw soft jaw chuck, I was wondering if the smaller swing on the Sherline vs the Taig would pose problems for Taig chuck on the Sherline lathe? The chuck is 3.25" and the swing on the Sherline is 3.5" I realize not much room for the jaws to move out, but that is not much of a concern for my application I have planned for it.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » The Home Machinist! » Lathes

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 5 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group