Machining a pulley

All discussion about lathes including but not limited to: South Bend, Hardinge, Logan, Monarch, Clausing and other HSM lathes, including imports

Moderators: Harold_V, GlennW

davec43
Posts: 52
Joined: Thu Dec 17, 2009 6:26 pm
Location: 108 Mile Ranch, BC

Re: Machining a pulley

Post by davec43 » Thu Mar 08, 2012 3:04 pm

Russ Hanscom wrote:Nice work on the soft jaws, but they were meant to be cut up! You can also buy them for a reasonable cost, or weld on material after they are pretty well cut away.
Thanks Russ, they are cut up now. They are for a Grizzly chuck G9819. Not the chuck I really wanted but budgetary restraints were imposed. I don't think I have seen soft jaws available anywhere with that configuration on the mating surface.
Dave C

Grizzly 12x36 lathe, Gorton 1-22 milling machine

davec43
Posts: 52
Joined: Thu Dec 17, 2009 6:26 pm
Location: 108 Mile Ranch, BC

Re: Machining a pulley

Post by davec43 » Thu Mar 08, 2012 3:09 pm

Maybe that is a std configuration that Enco carries.

http://www.use-enco.com/CGI/INSRIT?PART ... A=325-1458

I'll have to check it out.
Dave C

Grizzly 12x36 lathe, Gorton 1-22 milling machine

Russ Hanscom
Posts: 1601
Joined: Wed Mar 15, 2006 11:10 pm
Location: Farmington, NM

Re: Machining a pulley

Post by Russ Hanscom » Thu Mar 08, 2012 9:13 pm

My soft jaws have the same configuration and it appears to be standard. Just look under Amercican standard soft jaws.

Post Reply