Atlas crossfeed and compound nuts

All discussion about lathes including but not limited to: South Bend, Hardinge, Logan, Monarch, Clausing and other HSM lathes, including imports

Moderators: GlennW, Harold_V

Post Reply
earlgo
Posts: 1795
Joined: Sat Jan 29, 2011 11:38 am
Location: NE Ohio

Atlas crossfeed and compound nuts

Post by earlgo »

Image

My acquaintance Tom Ross in Nebraska makes these nuts to original specifications and they work very well. So if you need a replacement, this is the place to go.
This picture is for the cross feed nut for the Atlas 12" lathe P/N 537-041. He also can make the compound nut P/N 537-040.
His contact info is TRoss96586@aol.com
Just FYI.
--earlgo
Before you do anything, you must do something else first. - Washington's principle.
Top
Post Reply

Return to “Lathes”