Enco 91002 Clutch Question

Discussion on all milling machines vertical & horizontal, including but not limited to Bridgeports, Hardinge, South Bend, Clausing, Van Norman, including imports.

Moderators: Harold_V, GlennW

Torch
Posts: 1543
Joined: Wed Mar 17, 2010 7:58 am
Location: Muskoka

Re: Enco 91002 Clutch Question

Post by Torch » Tue Dec 01, 2015 4:18 pm

That's what I would do.

R8 has enough taper to hold itself while you tighten the draw bolt and more than the silly pin can provide when loaded. Do a search on this board and you will find lots of guys don't bother with the R8 key pin.

Harold_V
Posts: 17618
Joined: Fri Dec 20, 2002 11:02 pm
Location: Onalaska, WA USA

Re: Enco 91002 Clutch Question

Post by Harold_V » Tue Dec 01, 2015 4:20 pm

The collet key is there for a reason, although the machine can be used without one in place. The only real advantage in not having one is that the spindle won't develop an indented pattern that resembles the collet. With the key, collets always load in the same position, so the open portion of the collet leaves an identical pattern in the spindle over the long haul. Without the key, that doesn't happen because the collet locates randomly each time one is installed.

The key prevents the collet (or other tools, like a boring head) from rotating when the draw bar is tightened. Beyond that, it serves no real purpose. It is NOT intended to drive anything.

That being said, I have never made the decision to remove mine, and do not regret not doing so.

Harold
Wise people talk because they have something to say. Fools talk because they have to say something.

spro
Posts: 7532
Joined: Mon Feb 20, 2006 11:04 pm
Location: mid atlantic

Re: Enco 91002 Clutch Question

Post by spro » Tue Dec 01, 2015 7:28 pm

R-8 is perfect for these even though it's more a tractor axle than a jig borer. Yet, it was so powerful that the main issue was holding the head/column straight to the base.

Post Reply