Horizontal Mill
-
- Posts: 666
- Joined: Mon Jan 12, 2009 11:45 pm
- Location: Port Angeles, WA
- Contact:
Horizontal Mill
Does anybody know where I can obtain a schematic/manual for a Milwaukee Horizontal Mill model H serial-2-2633? A woodruff key fell out of the clutch assembly for the power feed. I have to remove this casing casting and...?
www.banninglocomotiveworks.com
www.littleengines.com
www.littleengines.com
-
- Posts: 2930
- Joined: Mon Nov 10, 2014 1:39 pm
- Location: Woodinville, Washington
Re: Horizontal Mill
Look on practical machinist forum. There are many horizontal mill manuals and expertise available there.
Moderator - Grand Scale Forum
Motive power : 1902 A.S.Campbell 4-4-0 American - 12 5/8" gauge, 1955 Ottaway 4-4-0 American 12" gauge
Ahaha, Retirement: the good life - drifting endlessly on a Sea of projects....
Motive power : 1902 A.S.Campbell 4-4-0 American - 12 5/8" gauge, 1955 Ottaway 4-4-0 American 12" gauge
Ahaha, Retirement: the good life - drifting endlessly on a Sea of projects....
Re: Horizontal Mill
Is this (CH) close enough? http://vintagemachinery.org/pubs/detail.aspx?id=7023
If not, look through the rest of the offerings.. notice there is a place to sort by machine type just above the list.
http://vintagemachinery.org/mfgindex/de ... 2098&tab=3
If not, look through the rest of the offerings.. notice there is a place to sort by machine type just above the list.
http://vintagemachinery.org/mfgindex/de ... 2098&tab=3
-
- Posts: 666
- Joined: Mon Jan 12, 2009 11:45 pm
- Location: Port Angeles, WA
- Contact:
Re: Horizontal Mill
Thanks Rudd!!! That will help.
www.banninglocomotiveworks.com
www.littleengines.com
www.littleengines.com