Power Draw bar

Discussion on all milling machines vertical & horizontal, including but not limited to Bridgeports, Hardinge, South Bend, Clausing, Van Norman, including imports.

Moderators: Harold_V, GlennW

Post Reply
RonnieJ
Posts: 5
Joined: Thu Aug 03, 2017 8:54 am

Power Draw bar

Post by RonnieJ » Thu Aug 10, 2017 2:29 pm

plan on making a power draw bar like is on the Tormach 440 for a PM727v -instead of using an impact wrench like Lee did. My question is, does anyone have an idea of what size bore for the actuator or pneumatic cylinder would be minimum to use - all else in the design is pretty clear to me.

ANY HELP will get big smiles
Thanks
Ron

Post Reply