bridgeport handwheel clutch collar - ball stuck

Discussion on all milling machines vertical & horizontal, including but not limited to Bridgeports, Hardinge, South Bend, Clausing, Van Norman, including imports.

Moderators: Harold_V, GlennW

dly31
Posts: 1042
Joined: Sun Jun 27, 2004 11:29 pm
Location: Northeast Alabama

Re: bridgeport handwheel clutch collar - ball stuck

Post by dly31 » Tue Dec 26, 2017 10:43 pm

I have had good results removing such stuck balls and broken dogbones where there seemed to be burrs by sticking a small tube to the ball, putting valve grinding compound into the hole, and gently pulling on the tube while rotating it to grind the burrs away.
Don Young

Post Reply