North Carolina made power draw bar for bridgeport

Discussion on all milling machines vertical & horizontal, including but not limited to Bridgeports, Hardinge, South Bend, Clausing, Van Norman, including imports.

Moderators: Harold_V, GlennW

Post Reply
User avatar
oscer
Posts: 262
Joined: Mon Feb 06, 2012 12:38 am
Location: Central PA

North Carolina made power draw bar for bridgeport

Post by oscer » Sun Dec 24, 2017 12:43 pm

Hi fellas
Wondering if any of you folks invested in the power draw bars made in the power draw bar her, https://www.ebay.com/itm/BRIDGEPORT-IMP ... 1438.l2649

I have a right angle attachment and think it would be pretty hard to get the draw bar extension installed if the power draw bar was in place. Any one out there using one of these and maybe figured out an easy way to install a right angle attachment?
"...that they are endowed by their creator with certain unalienable rights,that among these are life,liberty and the pursuit of happiness." Thomas Jefferson
"When the people find that they can vote themselves money, that will herald the end of the republic." Ben Franklin

Post Reply