INT/ISO30 collets

Discussion on all milling machines vertical & horizontal, including but not limited to Bridgeports, Hardinge, South Bend, Clausing, Van Norman, including imports.

Moderators: Harold_V, GlennW

Post Reply
wally318
Posts: 84
Joined: Sun Jun 05, 2011 1:06 am
Location: Kelowna, British Columbia

INT/ISO30 collets

Post by wally318 » Sun Dec 31, 2017 2:56 pm

In my rebuilding my Rockwell vert./Horz. mill and deciding on
tooling needed, I have often wondered whether there was such
an animal as 30 taper collet. Like in the pic.
I'm thinking they would come in very handy for using with
reduced shank drills in the Horizontal mode. Rather than giving up room
by putting a collet chuck in between.
Anyone ever see any of these or know where to get them?
The only ones I could find online are Asian made, but in metric and
not imperial sizes.
Attachments
collets.jpg

Post Reply