Gorton 9j Motor Plate

Discussion on all milling machines vertical & horizontal, including but not limited to Bridgeports, Hardinge, South Bend, Clausing, Van Norman, including imports.

Moderators: Harold_V, GlennW

Post Reply
architect
Posts: 3
Joined: Sat Dec 22, 2018 8:43 pm
Location: Deridder, Louisiana

Gorton 9j Motor Plate

Post by architect » Mon Dec 24, 2018 4:32 pm

I have just bought a Gorton 9J Vertical mill. I want to get an inverter. My motor name plate is gone.

Can anyone send me a picture of their nameplate?

Harold_V
Posts: 17538
Joined: Fri Dec 20, 2002 11:02 pm
Location: Onalaska, WA USA

Re: Gorton 9j Motor Plate

Post by Harold_V » Mon Dec 24, 2018 4:50 pm

Might be a good idea to post a picture of your machine. The 9J was built over a long period of time, and may have been powered by more than one motor, which offers the remote possibility of getting the wrong information. A picture might narrow down what your machine has, assuming there were options.

While I'm not up to speed on motors, we have a couple readers on this board who appear to dispense expert advice. If you provide them with enough information, you'll get a reliable answer.

H
Wise people talk because they have something to say. Fools talk because they have to say something.

Russ Hanscom
Posts: 1533
Joined: Wed Mar 15, 2006 11:10 pm
Location: Farmington, NM

Re: Gorton 9j Motor Plate

Post by Russ Hanscom » Mon Dec 24, 2018 5:18 pm

There is/was a Gorton forum on Yahoo. Lots of info and links there. I have a Gorton 1-22 so no help on the 9.

Post Reply