New member saying hi!

Discussion on all milling machines vertical & horizontal, including but not limited to Bridgeports, Hardinge, South Bend, Clausing, Van Norman, including imports.

Moderators: GlennW, Harold_V

Post Reply
PT Doc
Posts: 4
Joined: Sun Jan 20, 2019 7:59 pm

New member saying hi!

Post by PT Doc »

Hi guys! I just joined this forum and wanted to say hello before posting. I will be getting a milling machine delivered next month and will likely have some questions. I am happy to find a forum that is frequented regularly. I look forward to helping out too if I can.
curtis cutter
Posts: 559
Joined: Fri May 18, 2012 11:46 pm
Location: Curtis, WA

Re: New member saying hi!

Post by curtis cutter »

Tell us where you are from.
Gregg
Just let go of it, it will eventually unplug itself.
Richard_W
Posts: 2031
Joined: Fri Jan 10, 2003 1:00 am
Location: Molalla, Oregon

Re: New member saying hi!

Post by Richard_W »

Hi right back at you. Welcome.
RMinMN
Posts: 102
Joined: Tue Jan 02, 2018 8:50 am

Re: New member saying hi!

Post by RMinMN »

Welcome to the forum. Tell us a bit about the mill you are getting and where you live.
User avatar
neanderman
Posts: 896
Joined: Mon Jan 09, 2012 7:15 pm
Location: Cincinnati, Ohio, USA

Re: New member saying hi!

Post by neanderman »

Welcome aboard! We're a pretty friendly bunch and there is some real expertise here. So don't hesitate to ask a question, no matter how simplistic it might seem. No one is going to flame you (because Harold don't cotton to that!)
Ed

LeBlond Dual Drive, 15x30
US-Burke Millrite MVI
Atlas 618
Files, snips and cold chisels

Proud denizen of the former "Machine Tool Capitol of the World"
User avatar
Nelson
Posts: 85
Joined: Wed Nov 14, 2012 10:33 am
Location: New York

Re: New member saying hi!

Post by Nelson »

Hello Doc!
Nels
Founder, Hobby-Machinist.com
SB 10L Lathe in pieces, Burke #4, Van Norman #12
spro
Posts: 8016
Joined: Mon Feb 20, 2006 11:04 pm
Location: mid atlantic

Re: New member saying hi!

Post by spro »

Yes, hello Doc and hello to Nelson again.
Post Reply