I need help with a mill switch

Discussion on all milling machines vertical & horizontal, including but not limited to Bridgeports, Hardinge, South Bend, Clausing, Van Norman, including imports.

Moderators: Harold_V, GlennW

Post Reply
User avatar
Mark Hockett
Posts: 268
Joined: Wed Feb 20, 2008 8:46 pm
Location: Clinton WA.

I need help with a mill switch

Post by Mark Hockett » Sat Mar 30, 2019 6:58 pm

I have a early 90's vintage Well Setting milling machine. This is the typical 16 speed step pulley, 9"x 42" table Taiwanese mill. I am trying to replace the switch with one off of a Jet JTM-1 milling machine. I thought I had good pictures of the switch jumper configuration, but didn't. I removed a couple and now don't know which way they go back. Does anyone on this forum have a Jet JTM-1 mill that they could take a picture of the switch?

Thanks,
Mark Hockett

User avatar
mcostello
Posts: 812
Joined: Sat Jan 04, 2003 10:45 pm
Location: Lancaster, Ohio

Re: I need help with a mill switch

Post by mcostello » Sat Mar 30, 2019 8:49 pm

I have a Jet mill that I think fits the bill, will look tomorrow.

User avatar
Mark Hockett
Posts: 268
Joined: Wed Feb 20, 2008 8:46 pm
Location: Clinton WA.

Re: I need help with a mill switch

Post by Mark Hockett » Sun Mar 31, 2019 12:39 am

mcostello wrote:
Sat Mar 30, 2019 8:49 pm
I have a Jet mill that I think fits the bill, will look tomorrow.
Does it have the 2 speed 3 phase motor?
Mark Hockett

Russ Hanscom
Posts: 1533
Joined: Wed Mar 15, 2006 11:10 pm
Location: Farmington, NM

Re: I need help with a mill switch

Post by Russ Hanscom » Sun Mar 31, 2019 3:09 pm

Mark,

Here are some photos from an Enco 3 phase, 2 speed motor. If they are close, I will try to get more detail. I also have the wiring diagram, could send that as a pdf.
Attachments
DSC00881.JPG
DSC00882.JPG
DSC00883.JPG
DSC00884.JPG

User avatar
Mark Hockett
Posts: 268
Joined: Wed Feb 20, 2008 8:46 pm
Location: Clinton WA.

Re: I need help with a mill switch

Post by Mark Hockett » Sun Mar 31, 2019 8:25 pm

Russ Hanscom wrote:
Sun Mar 31, 2019 3:09 pm
Mark,

Here are some photos from an Enco 3 phase, 2 speed motor. If they are close, I will try to get more detail. I also have the wiring diagram, could send that as a pdf.
Russ,
That one is quite a bit different from mine, thanks for the picture.
Mark Hockett
Mark Hockett

User avatar
mcostello
Posts: 812
Joined: Sat Jan 04, 2003 10:45 pm
Location: Lancaster, Ohio

Re: I need help with a mill switch

Post by mcostello » Sun Mar 31, 2019 9:31 pm

No single speed.

User avatar
Mark Hockett
Posts: 268
Joined: Wed Feb 20, 2008 8:46 pm
Location: Clinton WA.

Re: I need help with a mill switch

Post by Mark Hockett » Sun Mar 31, 2019 10:05 pm

This is what my switch looks like,
IMG_0425.jpg
Mark Hockett

Post Reply