X3 owners need dimension

Discussion on all milling machines vertical & horizontal, including but not limited to Bridgeports, Hardinge, South Bend, Clausing, Van Norman, including imports.

Moderators: GlennW, Harold_V

Post Reply
ZipSnipe
Posts: 389
Joined: Wed Mar 29, 2006 7:25 am
Location: Daytona Beach, Fla

X3 owners need dimension

Post by ZipSnipe »

Hey I just need a rough dimension, just throw a rule across the bottom of your dovetail on the mill's table, thank you
Attachments
X3.JPG
Top
ZipSnipe
Posts: 389
Joined: Wed Mar 29, 2006 7:25 am
Location: Daytona Beach, Fla

Re: X3 owners need dimension

Post by ZipSnipe »

Found them

Dovetail angle (degrees): 55°
Dovetail height: 12mm
Dovetail width: 127mm
Top
Post Reply

Return to “Milling Machines”