David Moore Contact Information

This forum is dedicated to the Live Steam Hobbyist Community.

Moderators: cbrew, Harold_V

Post Reply
Marty_Knox
Posts: 1724
Joined: Thu Jan 09, 2003 6:50 pm
Location: Michigan, USA

David Moore Contact Information

Post by Marty_Knox »

Does anyone have an email address or phone number for David Moore?
The Hudson I'm working on has one of his Worthington hot water pumps.
User avatar
dwilloughby
Posts: 254
Joined: Fri Apr 18, 2008 8:39 pm
Location: North Las Vegas, NV

Re: David Moore Contact Information

Post by dwilloughby »

PM sent with phone and e-mail address
Marty_Knox
Posts: 1724
Joined: Thu Jan 09, 2003 6:50 pm
Location: Michigan, USA

Re: David Moore Contact Information

Post by Marty_Knox »

dwilloughby wrote: Tue Jul 03, 2018 1:18 pm PM sent with phone and e-mail address
Never got it, Dean.
Andypullen
Posts: 2166
Joined: Thu May 22, 2003 8:17 am
Location: Bel Air, MD

Re: David Moore Contact Information

Post by Andypullen »

Pam built a bunch of those pumps if you can't get a hold of Dave.
Clausing 10x24, Sheldon 12" shaper, ProtoTrak AGE-2 control cnc on a BP clone, Reed Prentice 14" x 30", Sanford MG 610 surface grinder, Kalamazoo 610 bandsaw, Hardinge HSL speed lathe, Hardinge HC chucker, Kearney and Trecker #2K plain horizontal mill, Haas TL-1 lathe.
Mountaineer
Posts: 276
Joined: Sun Dec 02, 2007 4:45 pm
Location: Canada

Re: David Moore Contact Information

Post by Mountaineer »

I miss Pam.

Mountaineer.
User avatar
dwilloughby
Posts: 254
Joined: Fri Apr 18, 2008 8:39 pm
Location: North Las Vegas, NV

Re: David Moore Contact Information

Post by dwilloughby »

Sent again...
Cary Stewart
Posts: 542
Joined: Wed Jun 08, 2011 5:54 pm

Re: David Moore Contact Information

Post by Cary Stewart »

Speaking of Pam. What has happened to her? I know that she got really busy at Sherline a couple of years ago.
Cary
765nkp
Posts: 777
Joined: Sun May 06, 2007 9:24 pm
Location: st louis, mo

Re: David Moore Contact Information

Post by 765nkp »

Just go to his website. www.dmprototypes.com
Marty_Knox
Posts: 1724
Joined: Thu Jan 09, 2003 6:50 pm
Location: Michigan, USA

Re: David Moore Contact Information

Post by Marty_Knox »

Thank You, Everyone! I was able to take the pump apart and put back together - it now works!
Andypullen
Posts: 2166
Joined: Thu May 22, 2003 8:17 am
Location: Bel Air, MD

Re: David Moore Contact Information

Post by Andypullen »

Pam is just fine. I spoke with her a week or so ago. Well, messaged with her.
Clausing 10x24, Sheldon 12" shaper, ProtoTrak AGE-2 control cnc on a BP clone, Reed Prentice 14" x 30", Sanford MG 610 surface grinder, Kalamazoo 610 bandsaw, Hardinge HSL speed lathe, Hardinge HC chucker, Kearney and Trecker #2K plain horizontal mill, Haas TL-1 lathe.
Post Reply