I just installed an Acu-Rite VUE DRO on my Enco mill. It has SENC 150 glass scales.
Is there a way to change the direction of the X scale? Currently the absolute readout increases when the table is moved from left to right. I would like the X scale to increase in value when the table is moved from right to left.
The X scale is mounted on the back side of the table (the scale is mounted to the table and the read head is attached to the saddle). I suppose I could swap ends on the scale and make a spacer to attach the read head to the saddle but I would think the software in the VUE would accommodate such a change.
Jim Skeel
Help with Acu-Rite VUE DRO
Moderator: Harold_V
Re: Help with Acu-Rite VUE DRO
Yes you can. It is in the manual but I don't have it in front of me at the moment. It's under the "encoder setup" title.
lg
no neat sig line
lg
no neat sig line
I am unique, just like everyone else.
Re: Help with Acu-Rite VUE DRO
I am unique, just like everyone else.
Re: Help with Acu-Rite VUE DRO
I found it. I did not realize there was a second page on the encoder setup menu.
Thanks for the help.
Thanks for the help.