A couple of example machines running under Centroid CNC Acorn
Posted: Fri Aug 18, 2017 8:23 pm
This one is a Dyna Myte DM2400. It was originally running under Mach3 parallel port, driving a Gecko G540 4 axis stepper driver. It was almost plug and play:
https://youtu.be/MvotXh04oZc
This one was a D&M4 picked up from one of our users on our For sale page. It was nearly complete, I just added the Acorn step and direction motion controller and finished wiring it up:
https://youtu.be/UYVaVO3A_Jk
Just a couple of examples. I am working on a couple more machines to run the Acorn Step/Dir motion controller. Both lathes. (Beta testing on the lathe software is about to begin). One lathe is an EMCOTURN 120, the other is a bit of an interesting one with a long story but essentially it is an Omniturn attachment being put on a very nice Victor Toolroom lathe. The Acorn will be driving DMM Technologies DYN4 AC Servo amplifiers and motors. Stay tuned....
Marty
https://youtu.be/MvotXh04oZc
This one was a D&M4 picked up from one of our users on our For sale page. It was nearly complete, I just added the Acorn step and direction motion controller and finished wiring it up:
https://youtu.be/UYVaVO3A_Jk
Just a couple of examples. I am working on a couple more machines to run the Acorn Step/Dir motion controller. Both lathes. (Beta testing on the lathe software is about to begin). One lathe is an EMCOTURN 120, the other is a bit of an interesting one with a long story but essentially it is an Omniturn attachment being put on a very nice Victor Toolroom lathe. The Acorn will be driving DMM Technologies DYN4 AC Servo amplifiers and motors. Stay tuned....
Marty