The Home Machinist!

A site dedicated to enthusiasts of all skill levels and disciplines of the metalworking hobby.
It is currently Fri May 24, 2013 10:05 am

View unanswered posts | View active topics


Board index » Home Shop CNC Machining » Home Shop CNC

All times are UTC - 5 hours




Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
jallenmorris
PostPosted: Thu Oct 30, 2008 9:22 am 
Offline

Joined: Tue Oct 21, 2008 7:20 am
Posts: 13
There is a guy in my city that is selling his CNC project. He has lots of parts, gantry, etc. He says x & y are complete, Z is not and he was building it to put a 3.5 hp router on it. it's based off the 24" x 48" Solsylva. He is not selling any steppers or controllers with it. I'm going to go take a look at it and try to figure out what parts are there, what parts I need, and how much $$ I think it will take to go from where he is to where it needs to be.

Any advice is greatly appreciated.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » Home Shop CNC Machining » Home Shop CNC

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group