The Home Machinist! • View topic - lathe chuck on mill table

View unanswered posts | View active topics

Board index » The Home Machinist! » The Photo Album

All times are UTC - 5 hours

lathe chuck on mill table

Moderators: Harold_V, RB211

Page 1 of 1

[ 6 posts ]

Print view

Previous topic | Next topic

Author

Message

retiredmachinist

Post subject: lathe chuck on mill table

Posted: Thu Dec 16, 2010 12:05 pm

Joined: Tue Dec 14, 2010 9:51 pm
Posts: 6
Location: Woodlawn, On ( Ottawa)

Here is a pic of the spare 3 jaw Southbend chuck I bolted onto a flatplate and had the welder make two slots on an arc. Much more stable than a vice, I used it at work before retiring.

_________________
57 wagon 408"BB with 14' Bonair travel trailer,71 Nova 355"SB, 07 2500HD with 26.5 Prowler 5th wheel travel trailer, 09 Impala LT, John Deere lawn tractor, CDN coordinator for ChevyTalk.org,
http://www.picturetrail.com/sfx/album/l ... rys57wagon

Top

Rex

Post subject: Re: lathe chuck on mill table

Posted: Thu Dec 16, 2010 6:01 pm

Joined: Wed Apr 28, 2010 6:29 am
Posts: 427
Location: DFW Texas

what sort of work was it suited for?

Top

retiredmachinist

Post subject: Re: lathe chuck on mill table

Posted: Thu Dec 16, 2010 9:01 pm

Joined: Tue Dec 14, 2010 9:51 pm
Posts: 6
Location: Woodlawn, On ( Ottawa)

We had to cut slots across shafts and our mill vice did not have V's in the jaw to keep the shaft square. This way you were always on center. I haven't used it for anything else as yet.

Top

ken572

Post subject: Re: lathe chuck on mill table

Posted: Thu Dec 16, 2010 9:25 pm

Joined: Sun Mar 14, 2010 8:11 pm
Posts: 1191
Location: Mesa, Arizona. 85201-1517

retiredmachinist,

Picture link is bad.. :cry:

Ken.

_________________
One must remember.
The best learning experiences come from
working with the older Masters.
Ken.

Top

retiredmachinist

Post subject: Re: lathe chuck on mill table

Posted: Fri Dec 17, 2010 12:26 pm

Joined: Tue Dec 14, 2010 9:51 pm
Posts: 6
Location: Woodlawn, On ( Ottawa)

Thanks Ken for the heads up, I re- pasted the link to my PictureTrail site onto my signature, I hope it works for you, Henry.

Top

ken572

Post subject: Re: lathe chuck on mill table

Posted: Fri Dec 17, 2010 2:04 pm

Joined: Sun Mar 14, 2010 8:11 pm
Posts: 1191
Location: Mesa, Arizona. 85201-1517

Henry,

You are very welcome.

You and little Henry have some very cool toy's

Ken.

_________________
One must remember.
The best learning experiences come from
working with the older Masters.
Ken.

Top

Page 1 of 1

[ 6 posts ]

Board index » The Home Machinist! » The Photo Album

All times are UTC - 5 hours

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: