The Home Machinist!

A site dedicated to enthusiasts of all skill levels and disciplines of the metalworking hobby.
It is currently Mon May 20, 2013 12:10 pm

View unanswered posts | View active topics


Board index » Home Shop CNC Machining » Home Shop CNC

All times are UTC - 5 hours




Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Print view Previous topic | Next topic 
Author Message
Marty_Escarcega
PostPosted: Mon Nov 14, 2011 8:27 pm 
Offline
Site Admin
User avatar

Joined: Wed Dec 18, 2002 8:17 pm
Posts: 1483
Location: Mesa, AZ USA
Ok, I managed to track down an Accuslide. It is a 2 axis bolt on CNC attachment for a Hardinge machine. I have measured from the top of the dovetail to the top of the table and come up with 5.625". (It actually has .375" spacers under one set of the linear slides making it 6") I don't know of any Hardinge with near that sort of swing. I believe some of the chuckers were 11" but even that is a bit short for the Accuslide.

What am I missing?

Thanks
Marty

_________________
"Jack of all Trades, Master of None"
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » Home Shop CNC Machining » Home Shop CNC

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group