Injector
- Trainman4602
- Posts: 3482
- Joined: Sat Oct 16, 2004 9:26 pm
- Location: New Jersey
Re: Injector
I think Amazon has them beat
ALLWAYS OPERATING MY TRAIN IN A SAFE MANNER USING AUTOMATIC AIR BRAKES
Re: Injector
Hi Greg,
Your pic of your 'D' bit 9 degrees tapered reamer looks to be considerably greater in degrees than 9. What is the OD and what length is the taper?
I have not found any engraving bits of small enough taper but I do use them sometimes to remove some of the metal before using my injector reamers. The engraving bits have a tendency to chatter because one side has a different taper to the other in effect providing rake on the cutting edge.
Cheers,
Julian
Your pic of your 'D' bit 9 degrees tapered reamer looks to be considerably greater in degrees than 9. What is the OD and what length is the taper?
I have not found any engraving bits of small enough taper but I do use them sometimes to remove some of the metal before using my injector reamers. The engraving bits have a tendency to chatter because one side has a different taper to the other in effect providing rake on the cutting edge.
Cheers,
Julian
Re: Injector
Hi,Julian,yre wright,the angle is steeper than 9 degrees I made a technical error.it came out at 14degrees,put it down to being too late at night,the shank size is 1/4inch,
That one is now in the bin,remade two (the correct angle this time) last night,
Thanks for the heads up on the deburs,
That one is now in the bin,remade two (the correct angle this time) last night,
Thanks for the heads up on the deburs,
It's better to try and fail than not to try at all,
- Trainman4602
- Posts: 3482
- Joined: Sat Oct 16, 2004 9:26 pm
- Location: New Jersey
Re: Injector
Greg
Where are you getting all these angles from?
Where are you getting all these angles from?
ALLWAYS OPERATING MY TRAIN IN A SAFE MANNER USING AUTOMATIC AIR BRAKES
Re: Injector
I got the working drawings for a 40oz injector I need to make a 9deg and a 13 deg Dbits,I just stuffed up setting my compound slide on the first one I made,but still a good training excersise
It's better to try and fail than not to try at all,
Re: Injector
If you are reading the numbers on the top slide angle graduations, or, compound, make sure you understand the difference between the angle on the side of what you are machining, and "included angle". Also, make sure your tool is exactly on center height, or, the surface you machine will not be a true taper.
David
David
Re: Injector
The problem I had was I just miss read the increments on the compound slide,and the tooling is dead center,
It's better to try and fail than not to try at all,
Re: Injector
Okay, keep us posted on your progress. As you can tell by the number of posts, many are quite interested.
David
David
Re: Injector
Update on progress,,,D reamers and depth guages done,
Just waiting for the brass to be delivered,will start on the body in the mean time,
Just waiting for the brass to be delivered,will start on the body in the mean time,
It's better to try and fail than not to try at all,
Re: Injector
Update for those interested,the body is made ,start on the cones this week,
I will post some pictures once I can get them small enough insize to post
I will post some pictures once I can get them small enough insize to post
It's better to try and fail than not to try at all,
Re: Injector
The complete body,just the nuts to make then start on the cones.
It's better to try and fail than not to try at all,