David Moore Contact Information
-
- Posts: 1724
- Joined: Thu Jan 09, 2003 6:50 pm
- Location: Michigan, USA
David Moore Contact Information
Does anyone have an email address or phone number for David Moore?
The Hudson I'm working on has one of his Worthington hot water pumps.
The Hudson I'm working on has one of his Worthington hot water pumps.
- dwilloughby
- Posts: 254
- Joined: Fri Apr 18, 2008 8:39 pm
- Location: North Las Vegas, NV
Re: David Moore Contact Information
PM sent with phone and e-mail address
-
- Posts: 1724
- Joined: Thu Jan 09, 2003 6:50 pm
- Location: Michigan, USA
Re: David Moore Contact Information
Never got it, Dean.
-
- Posts: 2166
- Joined: Thu May 22, 2003 8:17 am
- Location: Bel Air, MD
Re: David Moore Contact Information
Pam built a bunch of those pumps if you can't get a hold of Dave.
Clausing 10x24, Sheldon 12" shaper, ProtoTrak AGE-2 control cnc on a BP clone, Reed Prentice 14" x 30", Sanford MG 610 surface grinder, Kalamazoo 610 bandsaw, Hardinge HSL speed lathe, Hardinge HC chucker, Kearney and Trecker #2K plain horizontal mill, Haas TL-1 lathe.
-
- Posts: 276
- Joined: Sun Dec 02, 2007 4:45 pm
- Location: Canada
Re: David Moore Contact Information
I miss Pam.
Mountaineer.
Mountaineer.
- dwilloughby
- Posts: 254
- Joined: Fri Apr 18, 2008 8:39 pm
- Location: North Las Vegas, NV
Re: David Moore Contact Information
Sent again...
-
- Posts: 542
- Joined: Wed Jun 08, 2011 5:54 pm
Re: David Moore Contact Information
Speaking of Pam. What has happened to her? I know that she got really busy at Sherline a couple of years ago.
Cary
Cary
Re: David Moore Contact Information
Just go to his website. www.dmprototypes.com
-
- Posts: 1724
- Joined: Thu Jan 09, 2003 6:50 pm
- Location: Michigan, USA
Re: David Moore Contact Information
Thank You, Everyone! I was able to take the pump apart and put back together - it now works!
-
- Posts: 2166
- Joined: Thu May 22, 2003 8:17 am
- Location: Bel Air, MD
Re: David Moore Contact Information
Pam is just fine. I spoke with her a week or so ago. Well, messaged with her.
Clausing 10x24, Sheldon 12" shaper, ProtoTrak AGE-2 control cnc on a BP clone, Reed Prentice 14" x 30", Sanford MG 610 surface grinder, Kalamazoo 610 bandsaw, Hardinge HSL speed lathe, Hardinge HC chucker, Kearney and Trecker #2K plain horizontal mill, Haas TL-1 lathe.