Another possible option...
http://shop.sdp-si.com/catalog/product/ ... C29-Y24012
They take PayPal. I’ve purchased from them before and been happy.
Needing a gear
-
- Posts: 115
- Joined: Sat Sep 13, 2003 2:47 pm
- Location: El Paso, TX
Re: Needing a gear
Illigitimi non Carborundum
'96 Birmingham mill, Enco 13x40 GH and Craftsman 6x18 lathes, Reid 2C surface grinder. Duro Bandsaw and lots of tooling from 30+ years in the machining trades and 15+ years in refinery units. Now retired
'96 Birmingham mill, Enco 13x40 GH and Craftsman 6x18 lathes, Reid 2C surface grinder. Duro Bandsaw and lots of tooling from 30+ years in the machining trades and 15+ years in refinery units. Now retired
Re: Needing a gear
I must be really bad at searching. I spent a little time searching there and didn't see that. I think I was too focused on searching for one thing or something. I dunno. I already ordered from McMaster. I'll get a foot of gear stock and can turn the ends down to fit. I need to look up the spacing now since the hole is pretty wallered out. You can really see how much it moved and how much the diameter changed.
Dave
Dave
- seal killer
- Posts: 4696
- Joined: Sat Aug 18, 2007 10:58 pm
- Location: Ozark Mountains
Re: Needing a gear
Dave--
I love the word "wallered." I grew up in the deep south on the Texas Gulf Coast. A lot of stuff got wallered out down there. When I moved to the midwest, I used the term as in 'just waller it out a little . . . then it'll fit'.
I'll look back in on this thread to find out how the ice cream turns out.
--Bill
I love the word "wallered." I grew up in the deep south on the Texas Gulf Coast. A lot of stuff got wallered out down there. When I moved to the midwest, I used the term as in 'just waller it out a little . . . then it'll fit'.
I'll look back in on this thread to find out how the ice cream turns out.
--Bill
You are what you write.
Re: Needing a gear
Well, the ends of the new gear have been turned down for a few weeks now. I need to case harden it, but haven't had the time to mess with it more. I also still need to clamp the other half of the housing on the mill table and do some xy measurements to find out where the hole is supposed to go. In a perfect world, I'd say in the middle of that boss (from the outside) or the middle of that pocket (from the inside). Being die cast, that's probably pretty accurate. But I'd still like to know for sure.
When it's done, you can come have some ice cream! Hmmm... actually, the rest of the maker is at my aunt's in Baldwin City. Well, maybe I'll save ya some!
Dave
When it's done, you can come have some ice cream! Hmmm... actually, the rest of the maker is at my aunt's in Baldwin City. Well, maybe I'll save ya some!
Dave
Re: Needing a gear
The Nitty Gritty Dirt Band had a song called Fishin' in the Dark. I recall Mom loving the part of that song where they said "crick".
Dave
Re: Needing a gear
Which woulda been "creek" . I remember when we moved to Tennessee. This kid asking me "yall gone himmin" ?. He was saying "have you all gone swimming" in a different way but we got used to it real quick.