The Home Machinist!

I am looking for a pair of the 1 inch LE tender trucks. Anyone out there have a set for sale?

Dave, good luck and I hope you do well with the line.

Bruce

Has anyone thought of putting your initials 12 inches tall on the roof of the trailer so it can be seen by helicopters flying overhead?

I have several 1.5 inch scale locomotives that only have 2 injectors. No axle pump or hand pump.

I also ran many full size steam locomotives and they only have 2 injectors.

Axle pumps are a pain and hand pumps in 1.5 inch scale locos are near worthless.

Paul
I liked your setup for the air/signal lines on front of your loco. So I made a set for my New Pacific. That's what is great about this hobby. People sharing ideas with others. Thank you. Bruce

Jack,

I would like to talk about a low water alarm. Please email me off line at bgsberk at Comcast.net
Gene Lurwig referred me to you.
Thanks Bruce Saylor in PA

I guess there are no one inch scale modelers on here. OR my price is too high. SO I will drop the price of the above NEW 1 inch scale hand pump to $155. including shipping.

SALE PENDING

Donnie, changed my mind.

I just finished today and tested this 1 inch scale Little Engines hand pump. It is for sale for $175. including shipping in the lower 48 ONLY. Comes with short handle and tapped for 1/8 NPT fittings. Stroke is 7/8 inch.

Bruce SOLD

bgsberk@comcast.net

Donnie,

Call me when you get a chance, I'm interested, Bruce S. I am on club list.

Carl, The burner assembly is from Locoparts and is bolted to bottom of the mudring. Not much room to lower it as the third axle is just beneath the gas feed line. I'm thinking of dropping it a 1/4 inch and may be able to install a small arch. I know it should be only 2/3 back from the front. I will ...

Well I have come up with a possible thought. I will check out the feasibility then. It will be touchy!!!
If it works I'll post.
Bruce