Page 7 of 7

Re: 1911 Project

Posted: Sat Oct 10, 2020 4:55 pm
by GlennW
A gauge pin was then inserted into the barrel bore and indicated concentric to the lathe spindle axis.
Image

The reamer was then plunged to the desired chamber depth.
Image

The barrel was then flipped around and the crown was cut using the same technique.
Image

Now I just need to trim the barrel ramp back a little.

Re: 1911 Project

Posted: Sun Oct 11, 2020 8:54 am
by RSG
Lots of fussy work there no doubt Glenn!