Socket head cap screws

The Junk Drawer is for those Off Topical discussions where we can ask questions of the community that we feel might have the ability to help out.

Moderator: Harold_V

earlgo
Posts: 1794
Joined: Sat Jan 29, 2011 11:38 am
Location: NE Ohio

Re: Socket head cap screws

Post by earlgo »

I have to plead naivety in not knowing about the #12 screws. They are listed in both the Machinery's Handbook and the Mark's Mechanical Engineers' Handbook. The latter I used exclusively until someone mentioned the Machinery's. However, naivety is no excuse. A couple of the screw "slide" cards I have, Holochrome and Unbrako, don't list the #12s so it must be their fault. :roll:
Thanks again for the input.
--earlgo
Before you do anything, you must do something else first. - Washington's principle.
Post Reply