switching colors

Get community help here, post test messages, suggestions etc. I will also document here changes that take place such as maintenance and upgrades.

Moderators: Harold_V, Marty_Escarcega

Post Reply
User avatar
MikeG
Posts: 111
Joined: Sat Jan 04, 2003 6:05 pm
Location: Colorado Springs, Colorado

switching colors

Post by MikeG » Wed Mar 19, 2003 3:35 pm

Marty
Just a suggestion. When I place the cursor over new posts the writing changes from black to white, which makes it hard to read since the background is a tan color. Is this sometning I can change?

Thanks

MikeG
In the shop; a Jet 8x36 vert mill, Jet 13x40 lathe. Harig 612 SG. Burke #4 HM. Van Norman #76 piston griinder

User avatar
Marty_Escarcega
Site Admin
Posts: 1708
Joined: Wed Dec 18, 2002 8:17 pm
Location: Mesa, AZ USA

Re: switching colors

Post by Marty_Escarcega » Thu Mar 20, 2003 12:18 am

It should be fixed. Be sure to REFRESH your browser so you can see the change.
It is not something the user can tweak.
Marty
"Jack of all Trades, Master of None"

Post Reply