SPI Gauge block accessory kit

Buying, selling, trading and for giving away Items of interest to the Home Machinist Community. (Non-Commercial Only) *PLEASE BE SURE TO LIST CONTACT INFORMATION AND LOCATION OF ITEM*

Moderator: Harold_V

Post Reply
User avatar
SteveM
Posts: 6859
Joined: Mon Jun 27, 2005 6:18 pm
Location: Connecticut

SPI Gauge block accessory kit

Post by SteveM » Sat Mar 30, 2019 11:45 am

Here's a gauge block accessory kit. I have two and the number on the label on the other is an SPI part number.

It's the one shown here:
http://www.penntoolco.com/spi-gage-bloc ... -15-358-5/

The one is missing the long clamp and some of the shorter pieces. It has two long bars, two short bars (good to use as straightedges too) and both large and small radius tips.

With the smallest bars, it can measure up to about 2" outside and 1/3/8" inside.

With the larger bars, it's about 2-1/2 outside and 1" inside.

You could expand the outside measurements by using gauge blocks top and bottom of the stack and sticking out.

The screw has a quick release so that you don't have to thread it all the way to where you need it.

Some of the bars were still wrapped in their protective paper.

$75 or best offer plus shipping.

Preference given to long-time active members.

Steve
Attachments
GaugeBlockAccess (1).jpg
GaugeBlockAccess (2).jpg
GaugeBlockAccess (3).jpg
GaugeBlockAccess (4).jpg
GaugeBlockAccess (5).jpg
GaugeBlockAccess (6).jpg

Post Reply