The Home Machinist!

Project started today with making the hardest component - the bell-shaped sleave holding the ball !

More details here in danish but you can Google Translate to the right just under the menu line - choose whatever language you like in the combobox:

http://kelds.weebly.com/power-arm.html

Hope you enjoy !

Next part in the PowerArm project - the pivotting ball !

More details here in danish but you can Google Translate to the right just under the menu line - choose whatever language you like in the combobox:

http://kelds.weebly.com/power-arm.html

Hope you enjoy !

Looking good, Keld!

Harold

Harold_V wrote:Looking good, Keld!

Harold

Thx for the nice word !

Turning of a brass bowl to block the pivotting ball - the next part in the PowerArm project

Unfortunately ... no, fortunately I had to make some more equipment for my ball turning jig to do it !

More details here in danish but you can Google Translate to the right just under the menu line - choose whatever language you like in the combobox:

Look down on the site !

http://kelds.weebly.com/power-arm.html

Hope you enjoy !

Now the last parts and adjustments are made in this project !

More details here in danish but you can Google Translate to the right just under the menu line - choose whatever language you like in the combobox:

Look down on the site !

http://kelds.weebly.com/power-arm.html

Hope you enjoy !

ksor wrote:Hope you enjoy !

Thanks! I did.
Good luck with the knee of your mill. Let us know what problem you found.

Harold

Great project and execution, however I can not think of what is used for.