Page 1 of 1

Beginner's Project

Posted: Sun Jan 23, 2011 3:11 pm
by KellyJones
Finished a beginner's project this morning. Made a sine plate following Guy Lataurd's guidance in the Machinist's Bedside Reader. First picture is the drawing. I should probably learn to use TurboCad, but that's time way from the machines.
106_0291.JPG
Finished Sine Plate

Re: Beginner's Project

Posted: Sun Jan 23, 2011 3:16 pm
by KellyJones
Still haven't figured out the controls for the forum

More pictures

The dial indicator says the top of the plate is true and flat within 0.005". Probably good enough for my use.