Worm Screw Retro-Fit on a Taig Lathe

The Photo Album is a place for "Shop Shots" as well as pictures and descriptions of projects that we are working on. Show off your Shops, Machines, and your Projects!

Moderators: Harold_V, WJH

Post Reply
Hank.W.E
Posts: 53
Joined: Thu Aug 27, 2009 2:56 pm
Location: Ontario

Worm Screw Retro-Fit on a Taig Lathe

Post by Hank.W.E » Mon Feb 28, 2011 9:47 am

This is a photo to back up a question I asked in the "General Discussion" Forum. Here is the mock-up of my worm screw set up. I got the screw and the gear from an old rotary table. It works smooth as silk....I even made a little oil bath for the screw. Thanks for looking!
Hank
Attachments
tangent screw.jpg
tangent screw.jpg (8.42 KiB) Viewed 2082 times

Post Reply