This is a photo to back up a question I asked in the "General Discussion" Forum. Here is the mock-up of my worm screw set up. I got the screw and the gear from an old rotary table. It works smooth as silk....I even made a little oil bath for the screw. Thanks for looking!
Hank
Worm Screw Retro-Fit on a Taig Lathe
Moderator: Harold_V
Worm Screw Retro-Fit on a Taig Lathe
- Attachments
-
- tangent screw.jpg (8.42 KiB) Viewed 3776 times