Gas Turbine ECU/Fadec

This Forum is dedicated to the Hobbyist I.C. (Internal Combustion) Engine Community.

Moderators: Harold_V, JackF

Post Reply
hobbysteam
Posts: 16
Joined: Fri Mar 15, 2013 7:09 pm

Gas Turbine ECU/Fadec

Post by hobbysteam » Wed Oct 28, 2020 12:48 pm

Hello
I'm not sure if this request belongs here but here goes. Has anyone out there successfully assembled an ECU for a small gas turbine using Arduino UNO 3 or Mega boards and got it to where it is a useful engine controller. I have sourced my converter boards for the Hall tach, the K type EGT and the pressure transducer but I could use all the help I can get. If anyone wants to chime in here it would be much appreciated!
Thanks

Post Reply