Making Motorcyckle pistons, rods and cranks from billet

This Forum is dedicated to the Hobbyist I.C. (Internal Combustion) Engine Community.

Moderators: Harold_V, JackF

Post Reply
CruisingRam
Posts: 10
Joined: Wed Dec 28, 2005 6:16 pm
Location: Anchorage Alaska

Making Motorcyckle pistons, rods and cranks from billet

Post by CruisingRam » Wed Dec 28, 2005 9:59 pm

Anyone here do this? Not counting labor, how much does this cost for a home machinist to make? What is the smallest mill you can get away with to make, understanding that no crank or rod is bigger than 10 inches in diameter or 7 inches in length?
Top
speedsport
Posts: 45
Joined: Fri Feb 17, 2006 8:42 am
Location: Tulsa, Oklahoma
Contact:
Contact speedsport

mo'sickle parts

Post by speedsport » Mon Mar 27, 2006 12:23 am

you are really ambitious.
"good enough never is"
Top
Post Reply

Return to “I.C. Engines”