Has anybody on here built the Centaur 60cc horizontal open crank engine.
It was a deign by E.T. Westbury which featured in the UK magazine "Model Engineer" in 1957.
I would be interested to hear any good or bad experiences with this engine before I start making it.
Phil UK
Centaur Engine
Phil,
Mostly finished one, still need to make some changes on the governor linkage. Do you have all the castings? I had to fab the carburator and governor. Don't recall any big problems. Not sure the cooling system on mine is going to be adequate.
There is a picture at: http://tinyurl.com/d3fmm
Gary
Washington state,
USA
Mostly finished one, still need to make some changes on the governor linkage. Do you have all the castings? I had to fab the carburator and governor. Don't recall any big problems. Not sure the cooling system on mine is going to be adequate.
There is a picture at: http://tinyurl.com/d3fmm
Gary
Washington state,
USA
Vancouver, WA